MPC8349E-mITX-GP Board
Table 11. EEPROM Write Protect
J22.G
Jumper Off
Jumper On
Description
Serial EEPROM is write protected (WC not asserted).
Serial EEPROM is not write protected (WC asserted).
1.6.3
PCI Operating Frequency
An M66EN input pin determines the AC timing of the PCI interface. On the MPC8349E-mITX-GP board,
the state of this signal can be driven to 0 by the J22 jumper to select 33 MHz AC timing. If J22.F is not
driven to 0, the M66EN signal level is determined by the PCI agent card connected to PCI slot P1. If a 33
MHz only card is inserted, the M66EN signal is driven to 0 by the PCI agent card according to the PCI
specification, or it is driven to 1 if it can perform at 66 MHz. See Table 12 .
.
Table 12. M66EN Signal Status Selection
J22.F
Jumper Off
Jumper On
Description
M66EN signal is determined by the card plugged into the PCI slot.
M66EN signal is hardwired to 0, which is hard coded to 33 MHz PCI operation.
1.6.4
Reset Configuration Word
The reset configuration word (RCW) controls the clock ratios and other basic device functions such as PCI
host or agent mode, boot location, TSEC modes, and endian mode. The reset configuration word is divided
into reset configuration word lower (RCWL) and reset configuration word higher (RCWH) and is loaded
from the local bus during the power-on or hard reset flow. The default RCW low bit setting is
0x0404_0000. The default RCW high bit setting is 0xB460_A000.
The RCW is located at the lowest 64 bytes of the boot Flash memory, which is 0xFE00_0000 if the default
memory map is used.
Table 13. Default RCW in Flash Memory
Address
FE000000:
FE000010:
FE000020:
FE000030:
04040404
00000000
B0B0B0B0
A0A0A0A0
04040404
00000000
B0B0B0B0
A0A0A0A0
04040404
00000000
60606060
00000000
04040404
00000000
60606060
00000000
MPC8349E-mITX-GP Reference Design Platform User’s Guide, Rev. 0
Freescale Semiconductor
Preliminary—Subject to Change Without Notice
21
相关PDF资料
MPC8349E-MITXE BOARD REFERENCE FOR MPC8349
MPC8377E-MDS-PB BOARD MODULAR DEV SYSTEM
MPC8569E-MDS-PB BOARD MOD DEV SYSTEM MPC8569
MPC8572EAMC MPC8572 AMC RAPID SYSTEM
MPQ-ARM ISP 4PORT FOR ARM CORTEX MCU
MP SURGE SUPPRESSR 2/RJ11 MODEM/FAX
MR0A08BCYS35 IC MRAM 1MBIT 35NS 44TSOP
MR0D08BMA45R IC MRAM 1MBIT 45NS 48BGA
相关代理商/技术参数
MPC8349E-MITX-GP 制造商:Freescale Semiconductor 功能描述:MPC8349e-MITX-GP Industrial Re
MPC8349EVVAGD 功能描述:IC MPU PWRQUICC II PRO 672-TBGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:MPC83xx 标准包装:1 系列:MPC85xx 处理器类型:32-位 MPC85xx PowerQUICC III 特点:- 速度:1.2GHz 电压:1.1V 安装类型:表面贴装 封装/外壳:783-BBGA,FCBGA 供应商设备封装:783-FCPBGA(29x29) 包装:托盘
MPC8349EVVAGDB 功能描述:微处理器 - MPU 8349 TBGA NO PB W/ ENC RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324
MPC8349EVVAGFB 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:Integrated Host Processor Hardware Specifications
MPC8349EVVAJD 功能描述:IC MPU PWRQUICC II PRO 672-TBGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:MPC83xx 标准包装:1 系列:MPC85xx 处理器类型:32-位 MPC85xx PowerQUICC III 特点:- 速度:1.2GHz 电压:1.1V 安装类型:表面贴装 封装/外壳:783-BBGA,FCBGA 供应商设备封装:783-FCPBGA(29x29) 包装:托盘
MPC8349EVVAJDB 功能描述:微处理器 - MPU 8349 TBGA NO PB W/ ENC RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324
MPC8349EVVAJF 功能描述:IC MPU PWRQUICC II PRO 672-TBGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:MPC83xx 标准包装:1 系列:MPC85xx 处理器类型:32-位 MPC85xx PowerQUICC III 特点:- 速度:1.2GHz 电压:1.1V 安装类型:表面贴装 封装/外壳:783-BBGA,FCBGA 供应商设备封装:783-FCPBGA(29x29) 包装:托盘
MPC8349EVVAJFB 功能描述:微处理器 - MPU 8349 TBGA NO PB W/ ENC RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324